Epoxy Resin Volume & Weight Calculation Formula
To accurately calculate the amount of deep pour epoxy resin needed for your river table void:
Resin Required (kg) ≈ Volume (Liters) × 1.1 (Density factor)
Example: A table void measuring 150 cm long, 20 cm average width, and 5 cm deep = 150 × 20 × 5 ÷ 1,000 = 15 Liters (approx. 16.5 kg or 4.3 gallons). Recommended product: ArFlair 3 Gallon Deep Pour Epoxy Resin Kit (2:1 Ratio) →
Before you begin
- Dry, stable wood and a clean, level casting form
- A casting epoxy documented for the intended pour dimensions
- Compatible release and sealing materials
- Measuring tools and the protection specified in the product SDS
Measure the pour before choosing a resin
Record the channel length, width and depth, including irregular spaces around live edges. Share these dimensions with your resin supplier. Ask for the exact formulation’s permitted pour depth, batch size, working conditions and cure schedule; a general craft epoxy may not suit a deep river casting.
Prepare the wood and the casting form
Check that the wood is dry and stable. Remove loose material and prepare the surface using the resin supplier’s guidance. Confirm whether a compatible seal coat is needed. Secure the wood in a level, leak-resistant form and test the release method on a spare piece.
Make a representative sample
Use an offcut of the intended wood with the proposed resin, color and surface preparation. Review adhesion, bubbles and appearance after the specified cure. Approve the sample before scaling up, and record the material combination so you can repeat it.
Plan pouring, curing and finishing together
Follow the exact mixing ratio, batch limit and pour schedule in the current TDS. Larger pours can retain heat, so do not increase depth or batch size without supplier guidance. Allow the required cure before demolding and machining, and control sanding dust using the prescribed protection.
TAKE THIS WITH YOU
Choose a formulation for the measured pour, then validate the complete wood-and-resin combination in a sample.
Use the current TDS and SDS for the exact material you select. Processing requirements and suitable applications vary by formulation.
CHOOSE MATERIALS FOR THIS PROJECT
